Field of application
Suitable for fixing ceramic tiles, including porcelain tiles (size 40x40 cm and more, and with width to 1 cm), with water absorption less than 1%, on unreformed brick and concrete bases inside and outside of buildings. The mixture is used for wall and floor cladding. Can be used as a leveling layer.
Mixing of mortar
Dry mixture shut with pure water (water temperature from +15°С to 20°С) at the rate of 4.75-5.25 liters of water for 25 kg of mixture, then mix up for uniformly consistence without lumps with a help of speed-low drill with nozzle or mixer. Mortar mix hold for 3-5 minutes and then it is necessary to mix it up. Finished mortar mix useful life is at least 1 hour.
Work performance
Prepared mixture is applied on a facing surface with a help of paddle, float or filling knife and align by serrated spatula. Tiles are placed on applied mixture and then pressed on. Layer thickness under tile must be 2-10 mm. Spatula teeth must coincide with the size of tile (for example, the width and depth of teeth for tile with size 15x15 cm are 6 mm, the width and depth of teeth for tile with size 30x30 cm are 10 mm). Tiles shouldn’t be wet preliminary. Joint recommended width between tiles is no less than 2 mm.
Tiles must be placed no later than 20 minutes after putting mortar mix on base. Tile position can be removed during 10 after placing. Rejoining must be made no earlier than 24 hours.
Work conditions
Works should be done when the temperature of bases is from 5°С to +30°С, the air temperature is +20°С and relative humidity is 60%. Under other working condition technological characteristics of mixture can change.
Adhesive for inside and outside works. Maximum effective for outside applications. Does not require adding of additional emulsions.
Technical characteristics
Ц.1.ЗК2 ДСТУ Б В.2.7-126:2011
Structure: Cement, mineral fillers, chemical admixture
|
Discharge on 25 kg of dry mix
|
4,75 – 5,25 l
|
Thickness of applied layer
|
3 -12 mm
|
Possible technical moving time
|
at most 48 hours
|
Mortar mix useful life
|
at least 1 hour
|
Open time
|
at least 20 min
|
Correction time
|
at least 10 min
|
Tile shift
|
at most 0,5 mm
|
The strength of adhesion to the base
after storage in dry air conditions
|
at least 0,8 MPa
|
The strength of adhesion to the base after watering
|
at least 0,5 Mpa
|
The strength of adhesion to the base after alternate freezing and thawing , 50 circles
|
at least 0,5 МPа
|
The strength of adhesion to the base after temperature impact
|
at least 0,5 MPа
|
Base temperature
|
from +5°С to +30°С
|
Service temperature
|
from -30°С to +70*С
|
Discharge for 1 m² with the layer thickness 1 mm calculated using dry mixture
|
apr. 1,3 kg
|