Field of application
It is suitable for fixing ceramic tiles (no larger than 40x40 cm and water absorption no less than 1%) on nondeformable brick and concrete bases inside and outside the buildings. For rooms with high humidity. The mixture is suitable for wall and floor cladding. For external works it is necessary to use EKOMIX BS 102 with an appropriate additive while tile cladding with water absorption less than 1%. *Can be used as a leveling coat.
Mixing of morta
Dry mixture shut with pure water (water temperature from +15°С to 20°С) at the rate of 4.75-5.25 liters of water for 25 kg of mixture, then mix up for uniformly consistence without lumps with a help of speed-low drill with nozzle or mixer. Mortar mix hold for 3-5 minutes and then it is necessary to mix it up. Finished mortar mix useful life is at least 1 hour.
Work performance
Prepared mixture is applied on a facing surface with a help of paddle, float or filling knife or align by serrated spatula. Tiles are placed on applied mixture and then pressed on. Layer thickness under tile must be 2-10 mm. Spatula teeth must coincide with the size of tile (e.g., the width and depth of teeth for tile with size 30x30 cm are 10 mm). Tiles shouldn’t be wet preliminary. Joint recommended width between tiles is no less than 2 mm. Tiles must be placed no later than 20 minutes after putting mortar mix on base. Tile position can be removed during 10 after placing. Rejoining must be made no earlier than 24 hours.
Work conditions
Works should be done when the temperature of bases is from 5°С to +30°С, the air temperature is +20°С and degree of air saturation is 60%. Under other working condition technological characteristics of mixture can change. Reliable adhesive for rooms with high humidity. It is distinguished by high adhesion strength to surface.
Technical characteristics
Ц.2.ЗК1 DSTU Б В.2.7-126:2011
Structure: |
Cement, Цемент, mineral fillers, chemical admixture of leading manufacturers |
Discharge on 25 kg of dry mix |
4,75 – 5,25 l |
Consumption of redispersed polymeric powder (mix with gauged water) |
0,25 kg for 25 kg of dry mixture |
Thickness of applied layer |
3 -12 mm |
Possible technical moving time |
at most 48 hours |
Mortar mix useful life |
at least 1 hour |
Open time |
at least 20 min |
Correction time |
at least 10 min |
Tile shift |
at most 0,5 mm |
The strength of adhesion to the base after storage in dry air conditions |
at least 0,5 MPa |
The strength of adhesion to the base after watering |
at least 0,5 MPa |
Base temperature |
from +5°С to +30°С |
Service temperature |
from -30°С to +70*С |
Discharge for 1 m² with the layer thickness 1 mm calculated using dry mixture |
apr. 1,3 kg |